RFC 1471 (rfc1471) - Page 3 of 25

The Definitions of Managed Objects for the Link Control Protocol of the Point-to-Point Protocol

RFC 1471                      PPP/LCP MIB                      June 1993


           which the sole purpose was to debug implementations were
           explicitly excluded from the MIB.

      (2)  Consider evidence of current use and/or utility.

      (3)  Limit the total number of objects.

      (4)  Exclude objects which are simply derivable from others in
           this or other MIBs.

3.2.  Structure of the PPP

   This section describes the basic model of PPP used in developing the
   PPP MIB. This information should be useful to the implementor in
   understanding some of the basic design decisions of the MIB.

   The PPP is not one single protocol but a large family of protocols.
   Each of these is, in itself, a fairly complex protocol.  The PPP
   protocols may be divided into three rough categories:

   Control Protocols
      The Control Protocols are used to control the operation of the
      PPP. The Control Protocols include the Link Control Protocol
      (LCP), the Password Authentication Protocol (PAP), the Link
      Quality Report (LQR), and the Challenge Handshake Authentication
      Protocol (CHAP).

   Network Protocols
      The Network Protocols are used to move the network traffic over
      the PPP interface.  A Network Protocol encapsulates the datagrams
      of a specific higher-layer protocol that is using the PPP as a
      data link.  Note that within the context of PPP, the term "Network
      Protocol" does not imply an OSI Layer-3 protocol; for instance,
      there is a Bridging network protocol.

   Network Control Protocols (NCPs)
      The NCPs are used to control the operation of the Network
      Protocols. Generally, each Network Protocol has its own Network
      Control Protocol; thus, the IP Network Protocol has its IP Control
      Protocol, the Bridging Network Protocol has its Bridging Network
      Control Protocol and so on.

   This document specifies the objects used in managing one of these
   protocols, namely the Link Control Protocol and Link Quality
   Monitoring Protocol.






Kastenholz