RFC 2711 (rfc2711) - Page 1 of 6


IPv6 Router Alert Option



Alternative Format: Original Text Document



Network Working Group                                      C. Partridge
Request for Comments: 2711                                          BBN
Category: Standards Track                                    A. Jackson
                                                                    BBN
                                                           October 1999


                        IPv6 Router Alert Option

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (1999).  All Rights Reserved.

Abstract

   This memo describes a new IPv6 Hop-by-Hop Option type that alerts
   transit routers to more closely examine the contents of an IP
   datagram.  This option is useful for situations where a datagram
   addressed to a particular destination contains information that may
   require special processing by routers along the path.

1.0  Introduction

   New protocols, such as RSVP, use control datagrams which, while
   addressed to a particular destination, contain information that needs
   to be examined, and in some case updated, by routers along the path
   between the source and destination.  It is desirable to forward
   regular datagrams as rapidly as possible, while ensuring that the
   router processes these special control datagrams appropriately.
   Currently, however, the only way for a router to determine if it
   needs to examine a datagram is to at least partially parse upper
   layer data in all datagrams.  This parsing is expensive and slow.
   This situation is undesirable.

   This document defines a new option within the IPv6 Hop-by-Hop Header.
   The presence of this option in an IPv6 datagram informs the router
   that the contents of this datagram is of interest to the router and
   to handle any control data accordingly.  The absence of this option
   in an IPv6 datagram informs the router that the datagram does not
   contain information needed by the router and hence can be safely



Partridge & Jackson         Standards Track