RFC 3331 (rfc3331) - Page 2 of 94

Signaling System 7 (SS7) Message Transfer Part 2 (MTP2) - User Adaptation Layer

RFC 3331             SS7 MTP2 User Adaptation Layer       September 2002


Table of Contents

   1.  Introduction.............................................. 2
     1.1  Scope.................................................. 3
     1.2  Terminology............................................ 3
     1.3  M2UA Overview.......................................... 5
     1.4  Services Provided by the M2UA Adaptation Layer......... 7
     1.5  Functions Provided by the M2UA Layer................... 9
     1.6  Definition of the M2UA Boundaries..................... 12
   2.  Conventions.............................................. 16
   3.  Protocol Elements........................................ 16
     3.1  Common Message Header................................. 16
     3.2  M2UA Message Header................................... 22
     3.3  M2UA Messages......................................... 23
   4.  Procedures............................................... 58
     4.1  Procedures to Support the M2UA-User Layer............. 58
     4.2  Receipt of Primitives from the Layer Management....... 59
     4.3  AS and ASP State Maintenance.......................... 61
     4.4  Link Key Management Procedures........................ 73
   5.  Examples of MTP2 User Adaptation (M2UA) Procedures....... 75
     5.1  Establishment of associations between SGP and MGC..... 75
          examples
     5.2  ASP Traffic Fail-over Examples........................ 77
     5.3  SGP to MGC, MTP Level 2 to MTP Level 3 Boundary
          Procedures............................................ 78
   6.  Timer Values............................................. 85
   7.  Security Considerations.................................. 85
     7.1 Threats................................................ 85
     7.2 Protecting Confidentiality............................. 86
   8.  IANA Considerations...................................... 86
     8.1 SCTP Payload Protocol Identifier....................... 86
     8.2 M2UA Protocol Extensions............................... 86
   9.  Acknowledgements......................................... 87
   10. References............................................... 88
   Appendix A: Signalling Network Architecture.................. 90
   Authors' Addresses........................................... 92
   Full Copyright Statement..................................... 94

1.  Introduction

   This document defines a protocol for the backhauling of SS7 [1] MTP2
   User [2] [3] [4] (i.e. MTP3) signalling messages over IP using the
   Stream Control Transmission Protocol (SCTP) [8].  This protocol would
   be used between a Signalling Gateway (SG) and Media Gateway
   Controller (MGC).






Morneault, et. al.          Standards Track