RFC 2463 (rfc2463) - Page 2 of 18
Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6) Specification
Alternative Format: Original Text Document
RFC 2463 ICMPv6 (ICMP for IPv6) December 1998
8. Authors' Addresses.................................16
Appendix A - Changes since RFC 1885...................17
Full Copyright Statement..............................18
1. Introduction
The Internet Protocol, version 6 (IPv6) is a new version of IP. IPv6
uses the Internet Control Message Protocol (ICMP) as defined for IPv4
[RFC-792], with a number of changes. The resulting protocol is
called ICMPv6, and has an IPv6 Next Header value of 58.
This document describes the format of a set of control messages used
in ICMPv6. It does not describe the procedures for using these
messages to achieve functions like Path MTU discovery; such
procedures are described in other documents (e.g., [PMTU]). Other
documents may also introduce additional ICMPv6 message types, such as
Neighbor Discovery messages [IPv6-DISC], subject to the general rules
for ICMPv6 messages given in section 2 of this document.
Terminology defined in the IPv6 specification [IPv6] and the IPv6
Routing and Addressing specification [IPv6-ADDR] applies to this
document as well.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC-2119].
2. ICMPv6 (ICMP for IPv6)
ICMPv6 is used by IPv6 nodes to report errors encountered in
processing packets, and to perform other internet-layer functions,
such as diagnostics (ICMPv6 "ping"). ICMPv6 is an integral part of
IPv6 and MUST be fully implemented by every IPv6 node.
2.1 Message General Format
ICMPv6 messages are grouped into two classes: error messages and
informational messages. Error messages are identified as such by
having a zero in the high-order bit of their message Type field
values. Thus, error messages have message Types from 0 to 127;
informational messages have message Types from 128 to 255.
This document defines the message formats for the following ICMPv6
messages:
Conta & Deering Standards Track