RFC 2019 (rfc2019) - Page 1 of 6
Transmission of IPv6 Packets Over FDDI
Alternative Format: Original Text Document
Network Working Group M. Crawford
Request for Comments: 2019 Fermilab
Category: Standards Track October 1996
A Method for the Transmission of IPv6 Packets over FDDI Networks
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Introduction
This memo specifies the MTU and frame format for transmission of IPv6
[IPV6] packets on FDDI networks, including a method for MTU
determination in the presence of 802.1d bridges to other media. It
also specifies the method of forming IPv6 link-local addresses on
FDDI networks and the content of the Source/Target Link-layer Address
option used the the Router Solicitation, Router Advertisement,
Neighbor Solicitation, and Neighbor Advertisement messages described
in [DISC], when those messages are transmitted on an FDDI network.
Maximum Transmission Unit
FDDI permits a frame length of 4500 octets (9000 symbols), including
at least 22 octets (44 symbols) of Data Link encapsulation when
long-format addresses are used. Subtracting 8 octets of LLC/SNAP
header, this would, in principle, allow the IPv6 packet in the
Information field to be up to 4470 octets. However, it is desirable
to allow for the variable sizes and possible future extensions to the
MAC header and frame status fields. The default MTU size for IPv6
packets on an FDDI network is therefore 4352 octets. This size may
be reduced by a Router Advertisement [DISC] containing an MTU option
which specifies a smaller MTU, or by manual configuration of a
smaller value on each node. If a Router Advertisement is received
with an MTU option specifying an MTU larger than the default or the
manually configured value, that MTU option may be logged to system
management but must be otherwise ignored.
For purposes of this document, information received from DHCP is
considered "manually configured".
Crawford Standards Track