RFC 2097 (rfc2097) - Page 2 of 13
The PPP NetBIOS Frames Control Protocol (NBFCP)
Alternative Format: Original Text Document
RFC 2097 NBFCP January 1997
ACKNOWLEDGEMENTS ............................................. 13
CHAIR'S ADDRESS .............................................. 13
AUTHOR'S ADDRESS ............................................. 13
1. Introduction
PPP has three main components:
1. A method for encapsulating multi-protocol datagrams.
2. A Link Control Protocol (LCP) for establishing, configuring,
and testing the data-link connection.
3. A family of Network Control Protocols for establishing and
configuring different network-layer protocols.
In order to establish communications over a point-to-point link, each
end of the PPP link must first send LCP packets to configure and test
the data link. After the link has been established and optional
facilities have been negotiated as needed by the LCP, PPP must send
NBFCP packets to choose and configure the NBF network-layer protocol.
Once NBFCP has reached the Opened state, NBF datagrams can be sent
over the link.
The link will remain configured for communications until explicit LCP
or NBFCP packets close the link down, or until some external event
occurs (an inactivity timer expires or network administrator
intervention).
1.1. Specification of Requirements
In this document, several words are used to signify the requirements
of the specification. These words are often capitalized.
MUST This word, or the adjective "required", means that the
definition is an absolute requirement of the specification.
MUST NOT This phrase means that the definition is an absolute
prohibition of the specification.
SHOULD This word, or the adjective "recommended", means that there
may exist valid reasons in particular circumstances to
ignore this item, but the full implications should be
understood and carefully weighed before choosing a
different course.
Pall Standards Track