RFC 3331 (rfc3331) - Page 2 of 94
Signaling System 7 (SS7) Message Transfer Part 2 (MTP2) - User Adaptation Layer
Alternative Format: Original Text Document
RFC 3331 SS7 MTP2 User Adaptation Layer September 2002
Table of Contents
1. Introduction.............................................. 2
1.1 Scope.................................................. 3
1.2 Terminology............................................ 3
1.3 M2UA Overview.......................................... 5
1.4 Services Provided by the M2UA Adaptation Layer......... 7
1.5 Functions Provided by the M2UA Layer................... 9
1.6 Definition of the M2UA Boundaries..................... 12
2. Conventions.............................................. 16
3. Protocol Elements........................................ 16
3.1 Common Message Header................................. 16
3.2 M2UA Message Header................................... 22
3.3 M2UA Messages......................................... 23
4. Procedures............................................... 58
4.1 Procedures to Support the M2UA-User Layer............. 58
4.2 Receipt of Primitives from the Layer Management....... 59
4.3 AS and ASP State Maintenance.......................... 61
4.4 Link Key Management Procedures........................ 73
5. Examples of MTP2 User Adaptation (M2UA) Procedures....... 75
5.1 Establishment of associations between SGP and MGC..... 75
examples
5.2 ASP Traffic Fail-over Examples........................ 77
5.3 SGP to MGC, MTP Level 2 to MTP Level 3 Boundary
Procedures............................................ 78
6. Timer Values............................................. 85
7. Security Considerations.................................. 85
7.1 Threats................................................ 85
7.2 Protecting Confidentiality............................. 86
8. IANA Considerations...................................... 86
8.1 SCTP Payload Protocol Identifier....................... 86
8.2 M2UA Protocol Extensions............................... 86
9. Acknowledgements......................................... 87
10. References............................................... 88
Appendix A: Signalling Network Architecture.................. 90
Authors' Addresses........................................... 92
Full Copyright Statement..................................... 94
1. Introduction
This document defines a protocol for the backhauling of SS7 [1] MTP2
User [2] [3] [4] (i.e. MTP3) signalling messages over IP using the
Stream Control Transmission Protocol (SCTP) [8]. This protocol would
be used between a Signalling Gateway (SG) and Media Gateway
Controller (MGC).
Morneault, et. al. Standards Track