RFC 3034 (rfc3034) - Page 1 of 24
Use of Label Switching on Frame Relay Networks Specification
Alternative Format: Original Text Document
Network Working Group A. Conta
Request for Comments: 3034 Transwitch Corporation
Category: Standards Track P. Doolan
Ennovate
A. Malis
Vivace Networks, Inc.
January 2001
Use of Label Switching on Frame Relay Networks
Specification
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2001). All Rights Reserved.
Abstract
This document defines the model and generic mechanisms for
Multiprotocol Label Switching on Frame Relay networks. Furthermore,
it extends and clarifies portions of the Multiprotocol Label
Switching Architecture described in [ARCH] and the Label Distribution
Protocol (LDP) described in [LDP] relative to Frame Relay Networks.
MPLS enables the use of Frame Relay Switches as Label Switching
Routers (LSRs).
Table of Contents
1. Introduction................................................2
2. Terminology.................................................3
3. Special Characteristics of Frame Relay Switches.............4
4. Label Encapsulation.........................................5
5. Frame Relay Label Switching Processing......................6
5.1 Use of DLCIs..............................................6
5.2 Homogeneous LSPs..........................................7
5.3 Heterogeneous LSPs........................................7
5.4 Frame Relay Label Switching Loop Prevention and Control...7
5.4.1 FR-LSRs Loop Control - MPLS TTL Processing.............7
5.4.2 Performing MPLS TTL calculations.......................8
5.5 Label Processing by Ingress FR-LSRs......................12
Conta, et al. Standards Track