File Allocation Table
<file system> (FAT) The component of an
MS-DOS or
Windows 95 file system which describes the files, directories, and free space on a
hard disk or
floppy disk.
A disk is divided into partitions.
Under the FAT
file system each partition is divided into clusters, each of which can be one or more sectors, depending on the size of the partition.
Each cluster is either allocated to a file or directory or it is free (unused).
A directory lists the name, size, modification time and starting cluster of each file or subdirectory it contains.
At the start of the partition is a table (the FAT) with one entry for each cluster.
Each entry gives the number of the next cluster in the same file or a special value for "not allocated" or a special value for "this is the last cluster in the chain".
The first few clusters after the FAT contain the
root directory.
The FAT file system was originally created for the
CP/M[?]
operating system where files were catalogued using 8-bit addressing.
MS DOS's FAT allows only
8.3 filenames.
With the introduction of MS-DOS 4 an incompatible 16-bit FAT (FAT16) with 32-kilobyte clusters was introduced that allowed partitions of up to 2 gigabytes.
Microsoft later created
FAT32 to support partitions larger than two gigabytes and pathnames greater that 256 characters.
It also allows more efficient use of disk space since clusters are four kilobytes rather than 32 kilobytes. FAT32 was first available in
OEM Service Release 2 of
Windows 95 in 1996.
It is not fully
backward compatible with the 16-bit and 8-bit FATs.
IDG article (http://www.idg.net/idgframes/english/content.cgi?vc=docid_9-62525.html). (http://home.c2i.net/tkjoerne/os/fat.htm). (http://www.teleport.com/~brainy/). (http://209.67.75.168/hardware/fatgen.htm). (http://support.microsoft.com/support/kb/articles/q154/9/97.asp).
Compare:
NTFS.
[How big is a FAT?
Is the term used outside MS DOS?
How long is a FAT16 filename?]
